Under desk headphone hook

By Byteworks

Under-desk headphone hook: a C-clamp for 15-30 mm desk tops with a printed M10 screw and 20 mm knurled knob, and a 60 mm J-hook bolted to the clamp spine.

Model
stlstepglb
Customize for free
Under desk headphone hook, 3D printable model

Prompt that made this

Under-desk headphone hook. A 40 mm C-clamp for 15–30 mm desk tops, a 10 mm printed screw with a 20 mm knurled knob, and a 60 mm J-hook that bolts to the clamp.

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Hanging headphones from the underside of a desk without drilling the desk

The desk edge sits in the C throat. Turning the knob drives the M10 screw up through the lower jaw to press the desk against the upper jaw. The J-hook strap bolts flat against the outside of the spine so headphones hang on its lip, with the load carried by the clamp spine.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • Modular 21700 battery cell spacer tile, 3D printable modelModelFork

    Community

    Modular 21700 battery cell spacer tile

    Four staggered-honeycomb 21700 cell holder tiles laid out in a 2x2 lattice, each tile now 4 columns of 5 cells, with dovetail tabs on its right and top edges…

  • Corner clamp, 3D printable modelModelFork

    Community

    Corner clamp

    90° L-frame corner clamp, 80x80x20 with a 40 mm opening, a printed M10 screw through the jaw and a ball-swivel pad on the tip.

  • Drill bit index, 3D printable modelModelFork

    Community

    Drill bit index

    Drill-bit index block with 19 blind holes (1-10 mm in 0.5 mm steps, +0.2 mm clearance) in two rows, raised label bars, and an optional sliding lid in side ra…

  • Bench dog, 3D printable modelModelFork

    Community

    Bench dog

    Round bench dog peg, 19.8 mm dia and 50 mm tall, with a 6 mm flange head whose top edge is chamfered, and a 2 mm spring slot cut up the side of the shaft.

  • Bambu poop chute bucket, 3D printable modelModelFork

    Community

    Bambu poop chute bucket

    Two-part waste chute: a hollow 70x40x35 chute with a 28x18 hooked inlet lip and dovetail rails underneath, plus a separate 90x70x80 bucket whose lid has matc…

  • Parametric box with lid, 3D printable modelModelFork

    Community

    Parametric box with lid

    Two-part storage box (100x70x50 inside, 1.6 mm walls) with a recessed 4 mm lid, optional snap hook and slot on the front long side, and optional two-knuckle…

Browse creations