3D print
Prompt that made this
Bench dog, 19.8 mm diameter, 50 mm tall, 6 mm flange, 2 mm spring slot. Chamfered top.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Workbench dog that sits in a 3/4 inch (19 mm) bench hole to clamp work
The shaft drops into the bench hole. The flange head stops it and gives a pushing surface. A spring leaf sits in the side slot and presses against the hole wall to hold the dog at height.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
ModelForkCommunity
Tape measure holster
Open-top holster with an 82x42x70 mm pocket for a 5 m tape measure and a back-mounted belt loop that takes a 40x4 mm belt.
ModelForkCommunity
Printer purge bin
Open-top 100x70x60 purge bin with 1.2 mm walls and a rear J-hook with an 8 mm lip that hangs over a 6 mm rail or 2020 extrusion lip.
ModelForkCommunity
Parametric box with lid
Two-part storage box (100x70x50 inside, 1.6 mm walls) with a recessed 4 mm lid, optional snap hook and slot on the front long side, and optional two-knuckle…
ModelForkCommunity
PTFE tube clip
Small PTFE tube clip block with a snap-in C-slot channel and a 6 mm screw hole.
ModelForkCommunity
Bambu poop chute bucket
Two-part waste chute: a hollow 70x40x35 chute with a 28x18 hooked inlet lip and dovetail rails underneath, plus a separate 90x70x80 bucket whose lid has matc…
