3D print

Printer purge bin

By Byteworks

Open-top 100x70x60 purge bin with 1.2 mm walls and a rear J-hook with an 8 mm lip that hangs over a 6 mm rail or 2020 extrusion lip.

Model

stl step glb

Customize for free

Prompt that made this

Printer purge bin, 100 × 70 × 60 mm, 1.2 mm walls, 8 mm lip that hangs on a 6 mm lip or 2020 slot, open top.

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Catches purge and waste filament from a 3D printer; hangs from the printer frame.

The thin-walled box collects waste. The rear J-hook rests its bridge on top of a 6 mm rail lip, the 8 mm lip hangs on the far side, and the bin back wall bears against the rail's near face.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

ModelFork
Community
Modular 21700 battery cell spacer tile
Four staggered-honeycomb 21700 cell holder tiles laid out in a 2x2 lattice, each tile now 4 columns of 5 cells, with dovetail tabs on its right and top edges…
ModelFork
Community
Mudular 21700 battery cell spacer tile
4x4 honeycomb 21700 cell holder tile with thick 5.5 mm walls and half-cell cradles on all four edges. Dovetail tabs on its right edge (three) and top edge (f…
ModelFork
Community
PTFE tube clip
Small PTFE tube clip block with a snap-in C-slot channel and a 6 mm screw hole.
ModelFork
Community
Bench dog
Round bench dog peg, 19.8 mm dia and 50 mm tall, with a 6 mm flange head whose top edge is chamfered, and a 2 mm spring slot cut up the side of the shaft.
ModelFork
Community
Parametric box with lid
Two-part storage box (100x70x50 inside, 1.6 mm walls) with a recessed 4 mm lid, optional snap hook and slot on the front long side, and optional two-knuckle…
ModelFork
Community
Corner clamp
90° L-frame corner clamp, 80x80x20 with a 40 mm opening, a printed M10 screw through the jaw and a ball-swivel pad on the tip.