3D print
Prompt that made this
PTFE tube clip. A 20 × 12 × 10 mm body with a 4.2 mm C-slot and a 6 mm screw hole. Prints in minutes.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Holding a 4 mm OD PTFE tube against a frame or printer part
The tube snaps through the narrower slot into the round channel. A screw through the 6 mm hole clamps the block to a surface.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
ModelForkCommunity
Modular 21700 battery cell spacer tile
Four staggered-honeycomb 21700 cell holder tiles laid out in a 2x2 lattice, each tile now 4 columns of 5 cells, with dovetail tabs on its right and top edges…
ModelForkCommunity
Tape measure holster
Open-top holster with an 82x42x70 mm pocket for a 5 m tape measure and a back-mounted belt loop that takes a 40x4 mm belt.
ModelForkCommunity
Corner clamp
90° L-frame corner clamp, 80x80x20 with a 40 mm opening, a printed M10 screw through the jaw and a ball-swivel pad on the tip.
ModelForkCommunity
Printer purge bin
Open-top 100x70x60 purge bin with 1.2 mm walls and a rear J-hook with an 8 mm lip that hangs over a 6 mm rail or 2020 extrusion lip.
