3D print
Prompt that made this
Tape-measure holster, 80 × 40 × 70 mm pocket for a 5 m tape, belt loop 40 × 4 mm, open top.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Carrying a 5 m tape measure (80 x 40 x 70 mm) on a work belt
The tape drops into the open-top pocket and rests on the floor, held by the four walls. The belt threads through the loop slot on the back face, so the load goes belt to loop to back wall to body.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
ModelForkCommunity
Magnetic parts tray
Open parts tray 120x80x15 with 2 mm walls and 8 mm rounded corners, with optional four 20 mm magnet pockets under the floor.
ModelForkCommunity
18650 holder 4x
Four-cell 18650 holder with round open-top cradles between two slotted end walls and a bottom mounting tab with a 3 mm hole on each end.
ModelForkCommunity
Parametric box with lid
Two-part storage box (100x70x50 inside, 1.6 mm walls) with a recessed 4 mm lid, optional snap hook and slot on the front long side, and optional two-knuckle…
ModelForkCommunity
Filament spool holder
Two open A-frame spool stands with 8.2 mm axle holes at 50 mm height, optional 608 bearing seats on the inner faces, and a separate 8 mm x 100 mm axle.
ModelForkCommunity
Drill bit index
Drill-bit index block with 19 blind holes (1-10 mm in 0.5 mm steps, +0.2 mm clearance) in two rows, raised label bars, and an optional sliding lid in side ra…
