3D print
Prompt that made this
Drill-bit index, 140 × 50 × 22 mm. Two rows of holes 1–10 mm in 0.5 mm steps, each 0.2 mm over size, 16 mm deep, raised labels. Optional sliding lid.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Workshop storage and size lookup for twist drill bits from 1 to 10 mm
Each bit drops into a blind hole 0.2 mm larger than its nominal diameter and stands upright on a 6 mm floor. A raised bar in front of each hole marks its position. The optional lid slides along X in slots in two rails to cover the bits.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
ModelForkCommunity
Corner clamp
90° L-frame corner clamp, 80x80x20 with a 40 mm opening, a printed M10 screw through the jaw and a ball-swivel pad on the tip.
ModelForkCommunity
PTFE tube clip
Small PTFE tube clip block with a snap-in C-slot channel and a 6 mm screw hole.
ModelForkCommunity
Bambu poop chute bucket
Two-part waste chute: a hollow 70x40x35 chute with a 28x18 hooked inlet lip and dovetail rails underneath, plus a separate 90x70x80 bucket whose lid has matc…
ModelForkCommunity
Mudular 21700 battery cell spacer tile
4x4 honeycomb 21700 cell holder tile with thick 5.5 mm walls and half-cell cradles on all four edges. Dovetail tabs on its right edge (three) and top edge (f…
ModelForkCommunity
Filament spool holder
Two open A-frame spool stands with 8.2 mm axle holes at 50 mm height, optional 608 bearing seats on the inner faces, and a separate 8 mm x 100 mm axle.
