3D print
Prompt that made this
Filament spool holder. Two 80 × 20 × 70 mm A-frame stands with a 8.2 mm axle hole 50 mm off the bed, and a separate 8 mm axle 100 mm long. Optional 22 × 7 mm 608 bearing seats on the inside of each stand. Footprint 80 × 20 mm per stand, 3 mm walls.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Desktop 3D printer filament spool holder
The stands sit on the bed 60 mm apart. The axle passes through both axle holes, or through 608 bearings in the seats, and carries the spool so it can turn freely.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
ModelForkCommunity
Mudular 21700 battery cell spacer tile
4x4 honeycomb 21700 cell holder tile with thick 5.5 mm walls and half-cell cradles on all four edges. Dovetail tabs on its right edge (three) and top edge (f…
ModelForkCommunity
Drill bit index
Drill-bit index block with 19 blind holes (1-10 mm in 0.5 mm steps, +0.2 mm clearance) in two rows, raised label bars, and an optional sliding lid in side ra…
ModelForkCommunity
Corner clamp
90° L-frame corner clamp, 80x80x20 with a 40 mm opening, a printed M10 screw through the jaw and a ball-swivel pad on the tip.
ModelForkCommunity
Under desk headphone hook
Under-desk headphone hook: a C-clamp for 15-30 mm desk tops with a printed M10 screw and 20 mm knurled knob, and a 60 mm J-hook bolted to the clamp spine.
ModelForkCommunity
Printer purge bin
Open-top 100x70x60 purge bin with 1.2 mm walls and a rear J-hook with an 8 mm lip that hangs over a 6 mm rail or 2020 extrusion lip.
ModelForkCommunity
Filament guide arm
A 120x16x8 filament-guide arm with a 6 mm slot clamp at one end and a ball stud at the other, plus a separate 8 mm eyelet with a 2.4 mm bore that snaps onto…