Bambu poop chute bucket

By Byteworks

Two-part waste chute: a hollow 70x40x35 chute with a 28x18 hooked inlet lip and dovetail rails underneath, plus a separate 90x70x80 bucket whose lid has matching dovetail grooves, with optional 6x2 mm magnet pockets on the chute back.

Model
stlstepglb
Customize for free
Bambu poop chute bucket, 3D printable model

Prompt that made this

Bambu-style poop chute and bucket. A 70 × 40 × 35 mm chute with a 28 × 18 mm inlet lip that hooks a rectangular waste outlet, and a separate 90 × 70 × 80 mm bucket that slides onto a dovetail under the chute. Optional 6 × 2 mm magnet pockets on the chute back. 1.6 mm walls, no supports.

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Catches purge waste from a Bambu-style printer outlet in a removable bucket.

The inlet lip drops into the rectangular waste outlet and the hook tab catches its edge. Waste falls down the tapered 1.6 mm wall passage through the open bottom, past the dovetail rails, into the bucket. The bucket slides onto the rails along Y and is held by the dovetail undercut. Optional magnets sit in blind pockets on the chute back. Everything prints without supports, with walls at 45 degrees or less and the bucket lid printed face down.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • Corner clamp, 3D printable modelModelFork

    Community

    Corner clamp

    90° L-frame corner clamp, 80x80x20 with a 40 mm opening, a printed M10 screw through the jaw and a ball-swivel pad on the tip.

  • Filament spool holder, 3D printable modelModelFork

    Community

    Filament spool holder

    Two open A-frame spool stands with 8.2 mm axle holes at 50 mm height, optional 608 bearing seats on the inner faces, and a separate 8 mm x 100 mm axle.

  • Drill bit index, 3D printable modelModelFork

    Community

    Drill bit index

    Drill-bit index block with 19 blind holes (1-10 mm in 0.5 mm steps, +0.2 mm clearance) in two rows, raised label bars, and an optional sliding lid in side ra…

  • Under desk headphone hook, 3D printable modelModelFork

    Community

    Under desk headphone hook

    Under-desk headphone hook: a C-clamp for 15-30 mm desk tops with a printed M10 screw and 20 mm knurled knob, and a 60 mm J-hook bolted to the clamp spine.

  • Bench dog, 3D printable modelModelFork

    Community

    Bench dog

    Round bench dog peg, 19.8 mm dia and 50 mm tall, with a 6 mm flange head whose top edge is chamfered, and a 2 mm spring slot cut up the side of the shaft.

  • Printer purge bin, 3D printable modelModelFork

    Community

    Printer purge bin

    Open-top 100x70x60 purge bin with 1.2 mm walls and a rear J-hook with an 8 mm lip that hangs over a 6 mm rail or 2020 extrusion lip.

Browse creations