3D print
Prompt that made this
18650 battery holder for four cells side by side. Four round cradles 18.5 mm in diameter and 66 mm long between end walls, with slots in the end walls for nickel strip or spring contacts, 2 mm walls, and mounting tabs with 3 mm holes on both ends.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Holding four 18650 lithium cells side by side in a battery pack or project box
Each cell lies in an 18.5 mm round cradle held by 2 mm walls and trapped lengthwise between the end walls, where slots pass nickel strip or spring contacts to the terminals. Tabs on both ends screw the holder down.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
ModelForkCommunity
Filament spool holder
Two open A-frame spool stands with 8.2 mm axle holes at 50 mm height, optional 608 bearing seats on the inner faces, and a separate 8 mm x 100 mm axle.
ModelForkCommunity
Drill bit index
Drill-bit index block with 19 blind holes (1-10 mm in 0.5 mm steps, +0.2 mm clearance) in two rows, raised label bars, and an optional sliding lid in side ra…
ModelForkCommunity
Bambu poop chute bucket
Two-part waste chute: a hollow 70x40x35 chute with a 28x18 hooked inlet lip and dovetail rails underneath, plus a separate 90x70x80 bucket whose lid has matc…
ModelForkCommunity
Modular 21700 battery cell spacer tile
Four staggered-honeycomb 21700 cell holder tiles laid out in a 2x2 lattice, each tile now 4 columns of 5 cells, with dovetail tabs on its right and top edges…
ModelForkCommunity
PTFE tube clip
Small PTFE tube clip block with a snap-in C-slot channel and a 6 mm screw hole.
