3D print
Modular 21700 battery cell spacer tile
By Byteworks
Four staggered-honeycomb 21700 cell holder tiles laid out in a 2x2 lattice, each tile now 4 columns of 5 cells, with dovetail tabs on its right and top edges that lock into sockets on the left and bottom edges of the next tile.
Prompt that made this
Can we add dovetails in the locations indicated in this sketch, highlighted in red?
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Holder that keeps 21700 Li-ion cells upright in a tight staggered honeycomb pack, and can be extended by interlocking tiles.
Each cell drops through a 21.5 mm bore in the 6 mm flange. Tiles join side to side and end to end by dovetails: tabs on the right and top edges slide into sockets on the left and bottom edges of the neighbouring tile. The hex lattice continues across tile joints, so cell spacing is the same everywhere.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
ModelForkCommunity
Filament spool holder
Two open A-frame spool stands with 8.2 mm axle holes at 50 mm height, optional 608 bearing seats on the inner faces, and a separate 8 mm x 100 mm axle.
ModelForkCommunity
Filament guide arm
A 120x16x8 filament-guide arm with a 6 mm slot clamp at one end and a ball stud at the other, plus a separate 8 mm eyelet with a 2.4 mm bore that snaps onto…
ModelForkCommunity
Tape measure holster
Open-top holster with an 82x42x70 mm pocket for a 5 m tape measure and a back-mounted belt loop that takes a 40x4 mm belt.
ModelForkCommunity
18650 holder 4x
Four-cell 18650 holder with round open-top cradles between two slotted end walls and a bottom mounting tab with a 3 mm hole on each end.
ModelForkCommunity
Corner clamp
90° L-frame corner clamp, 80x80x20 with a 40 mm opening, a printed M10 screw through the jaw and a ball-swivel pad on the tip.
ModelForkCommunity
Parametric box with lid
Two-part storage box (100x70x50 inside, 1.6 mm walls) with a recessed 4 mm lid, optional snap hook and slot on the front long side, and optional two-knuckle…