3D print
Prompt that made this
Clamp
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Holding workpieces together on a bench
Turning the cross handle advances the screw through the threaded upper arm, pressing the pad against the workpiece on the fixed lower jaw. The load runs through the spine of the C.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
ModelForkCommunity
Jack saddle pad
Bottle jack saddle pad: 55 mm disc with a raised locating ring on top, a 28 mm piston boss underneath and four drain holes on a 36 mm bolt circle.
ModelForkCommunity
Shop vac hose adapter
Stepped tube adapter: a 60 mm long, 32 mm OD hose spigot, a 40 mm cone, then a 50 mm long socket with 58 mm inner diameter, 2.5 mm walls and a slight frictio…
ModelForkCommunity
Mudular 21700 battery cell spacer tile
4x4 honeycomb 21700 cell holder tile with thick 5.5 mm walls and half-cell cradles on all four edges. Dovetail tabs on its right edge (three) and top edge (f…
ModelForkCommunity
Under desk headphone hook
Under-desk headphone hook: a C-clamp for 15-30 mm desk tops with a printed M10 screw and 20 mm knurled knob, and a 60 mm J-hook bolted to the clamp spine.
ModelForkCommunity
Cable drag chain
Five identical separate drag-chain links, 15x10 mm inside and 20 mm long, snap-pinned at the sides and posed in a gentle curve, with a top bar and an open to…
ModelForkCommunity
Bevel gear pair 90
Two meshing 90-degree bevel gears (16T and 32T, module 2) sharing a common apex at the origin, each with a 6 mm x 15 mm integral shaft stub.