Skådis thread spools holder

By Byteworks

Hang-on comb plates for an IKEA Skadis board; each plate has hooks that drop into the pegboard slots and sloped blade pegs with rounded corners that carry the thread spools.

Laser
svg
Customize for free
Skådis thread spools holder, laser-cut design

Cut settings: 3 mm birch plywood · 600 × 400 · 1 sheet · 2.5 m of cut

Prompt that made this

Skadis thread spools holder

Open the model

Made in Voloom from the prompt under the model. Download the cut sheets as they are, or fork a copy to change the material thickness and every size on the right — the joints re-cut to fit, without spending credits.

Make it fit your stock

Measure your sheet first. In the editor, set the thickness to match and every slot and tab re-cuts to fit. Change the sheet size and the parts nest again. Neither spends credits.

Download an SVG per sheet and send it to your laser cutter.

More to make

  • IKEA Skådis headphone holder, 3D printable modelModelFork

    Community

    IKEA Skådis headphone holder

    IKEA Skådis headphone holder: two pegs on 40 mm centres, a 90 mm wide R55 U-cradle with 3 mm walls and 6 mm lips, and an optional side cable hook.

  • IKEA Skådis bin, laser-cut designLaserFork

    Laser cut

    IKEA Skådis bin

    An open tray on two hooked side brackets that hang on an IKEA Skadis board, with a floor, a front wall and a back wall.

  • IKEA Skådis bin, 3D printable modelModelFork

    skadis bin

    IKEA Skadis bin

    A bin that hooks straight into your Skadis board with no clips. Three cells wide to start, 120 mm, with a curved front so you can reach in.

  • IKEA Skådis cable hook, 3D printable modelModelFork

    Community

    IKEA Skådis cable hook

    IKEA Skådis pegboard cable hook with a 4 mm back plate, two drop-in pegs on 40 mm centres, and three 8 mm wide J-hooks in a vertical row 18 mm apart.

  • IKEA Skadis tray, laser-cut designLaserFork

    Laser cut

    IKEA Skadis tray

    A boxy open tray whose two rectangular side walls are hooked brackets for an IKEA Skadis board, with finger-jointed bottom and front and a back wall between…

  • IKEA Skådis screwdriver holder, 3D printable modelModelFork

    Community

    IKEA Skådis screwdriver holder

    Two-piece IKEA Skådis screwdriver holder for printing, now stood upright as it hangs: a vertical back plate with four rounded J-pegs and two swept supports f…

Browse creations