IKEA Skådis headphone holder

By Byteworks

IKEA Skådis headphone holder: two pegs on 40 mm centres, a 90 mm wide R55 U-cradle with 3 mm walls and 6 mm lips, and an optional side cable hook.

Model
stlstepglb
Customize for free
IKEA Skådis headphone holder, 3D printable model

Prompt that made this

IKEA Skadis headphone holder. Two Skadis pegs on 40 mm centres, a 90 mm-wide U-cradle 18 mm deep with a 6 mm lip so the headband does not slide off, and an optional side hook for the cable. Cradle radius 55 mm. 3 mm walls.

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Hanging headphones from an IKEA Skådis pegboard

The pegs drop into the board slots and carry the load through the plate and neck. The headband rests in the R55 cradle, and the lips stop it sliding sideways. The optional side hook holds the cable.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • Skådis thread spools holder, laser-cut designLaserFork

    Laser cut

    Skådis thread spools holder

    Hang-on comb plates for an IKEA Skadis board; each plate has hooks that drop into the pegboard slots and sloped blade pegs with rounded corners that carry th…

  • IKEA Skådis bin, 3D printable modelModelFork

    skadis bin

    IKEA Skadis bin

    A bin that hooks straight into your Skadis board with no clips. Three cells wide to start, 120 mm, with a curved front so you can reach in.

  • IKEA Skådis plier holder, 3D printable modelModelFork

    Community

    IKEA Skådis plier holder

    IKEA Skådis plier holder: a 100 mm bar with five 12x8 mm slots, 8 mm deep on 18 mm pitch, cut into its open front face, on a 4 mm back plate with two drop-in…

  • IKEA Skådis organizer tray with dividers, laser-cut designLaserFork

    Laser cut

    IKEA Skådis organizer tray with dividers

    Shorter open tray with dividers, hung on a Skadis board by two hooked side brackets that curve down to a low front.

  • IKEA Skådis tablet holder, 3D printable modelModelFork

    Community

    IKEA Skådis tablet holder

    IKEA Skådis tablet holder: 4 hook pegs on an 80x40 pattern, a 180x18 slot open at the top of the cradle and tilted 70 degrees, a 10 mm front lip and a 12 mm…

  • IKEA Skadis tray, laser-cut designLaserFork

    Laser cut

    IKEA Skadis tray

    A boxy open tray whose two rectangular side walls are hooked brackets for an IKEA Skadis board, with finger-jointed bottom and front and a back wall between…

Browse creations