IKEA Skådis tablet holder

By Byteworks

IKEA Skådis tablet holder: 4 hook pegs on an 80x40 pattern, a 180x18 slot open at the top of the cradle and tilted 70 degrees, a 10 mm front lip and a 12 mm cable notch cut through the front wall and lip into the slot.

Model
stlstepglb
Customize for free
IKEA Skådis tablet holder, 3D printable model

Prompt that made this

IKEA Skadis tablet holder. Four pegs on a 80 × 40 mm pattern, a 180 × 18 mm slot at 70°, 10 mm front lip, 12 mm cable notch.

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Hanging a tablet on an IKEA Skådis pegboard

The four hook pegs drop into the board and carry the load. The tablet edge sits in the open tilted slot, leans back at 70 degrees from horizontal and is retained by the 10 mm front lip. A cable exits through the 12 mm notch in the front wall.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • IKEA Skådis organizer tray with dividers, laser-cut designLaserFork

    Laser cut

    IKEA Skådis organizer tray with dividers

    Shorter open tray with dividers, hung on a Skadis board by two hooked side brackets that curve down to a low front.

  • IKEA Skådis bin, 3D printable modelModelFork

    skadis bin

    IKEA Skadis bin

    A bin that hooks straight into your Skadis board with no clips. Three cells wide to start, 120 mm, with a curved front so you can reach in.

  • IKEA Skådis phone holder, 3D printable modelModelFork

    Community

    IKEA Skådis phone holder

    IKEA Skådis pegboard phone holder with two hook pegs on 40 mm centres and a tilted 78 x 18 mm phone slot at 65 degrees with a 6 mm front lip and an 8 mm cabl…

  • IKEA Skådis bin, laser-cut designLaserFork

    Laser cut

    IKEA Skådis bin

    An open tray on two hooked side brackets that hang on an IKEA Skadis board, with a floor, a front wall and a back wall.

  • IKEA Skådis cable hook, 3D printable modelModelFork

    Community

    IKEA Skådis cable hook

    IKEA Skådis pegboard cable hook with a 4 mm back plate, two drop-in pegs on 40 mm centres, and three 8 mm wide J-hooks in a vertical row 18 mm apart.

  • Skådis thread spools holder, laser-cut designLaserFork

    Laser cut

    Skådis thread spools holder

    Hang-on comb plates for an IKEA Skadis board; each plate has hooks that drop into the pegboard slots and sloped blade pegs with rounded corners that carry th…

Browse creations