IKEA Skådis organizer tray with dividers

By Byteworks

Shorter open tray with dividers, hung on a Skadis board by two hooked side brackets that curve down to a low front.

Laser
svg
Customize for free
IKEA Skådis organizer tray with dividers, laser-cut design

Cut settings: 3 mm birch plywood · 600 × 400 · 1 sheet · 3.3 m of cut

Prompt that made this

Skadis tray. Open finger-jointed tray that hangs on an IKEA Skadis pegboard. add dividers and make shorter make it go shallower in front and sides go down with a curve. remove the text

Open the model

Made in Voloom from the prompt under the model. Download the cut sheets as they are, or fork a copy to change the material thickness and every size on the right — the joints re-cut to fit, without spending credits.

Make it fit your stock

Measure your sheet first. In the editor, set the thickness to match and every slot and tab re-cuts to fit. Change the sheet size and the parts nest again. Neither spends credits.

Download an SVG per sheet and send it to your laser cutter.

More to make

  • IKEA Skådis bin, 3D printable modelModelFork

    skadis bin

    IKEA Skadis bin

    A bin that hooks straight into your Skadis board with no clips. Three cells wide to start, 120 mm, with a curved front so you can reach in.

  • IKEA Skadis tray, laser-cut designLaserFork

    Laser cut

    IKEA Skadis tray

    A boxy open tray whose two rectangular side walls are hooked brackets for an IKEA Skadis board, with finger-jointed bottom and front and a back wall between…

  • IKEA Skådis phone holder, 3D printable modelModelFork

    Community

    IKEA Skådis phone holder

    IKEA Skådis pegboard phone holder with two hook pegs on 40 mm centres and a tilted 78 x 18 mm phone slot at 65 degrees with a 6 mm front lip and an 8 mm cabl…

  • IKEA Skådis modem cradle for coda56, 3D printable modelModelFork

    Community

    IKEA Skådis modem cradle for coda56

    IKEA Skådis hook bracket: a 5 mm back plate with eight drop-in hooks, a 173 mm wide open-top cradle for a Hitron CODA 56 modem, and two diagonal corner lips…

  • Skådis thread spools holder, laser-cut designLaserFork

    Laser cut

    Skådis thread spools holder

    Hang-on comb plates for an IKEA Skadis board; each plate has hooks that drop into the pegboard slots and sloped blade pegs with rounded corners that carry th…

  • IKEA Skådis hook, 3D printable modelModelFork

    Community

    IKEA Skådis hook

    IKEA Skådis pegboard hook: two 5 mm pegs on 40 mm centres, a 4 mm back plate and a 12 mm wide J-hook projecting 35 mm, with an optional second hook 20 mm lower.

Browse creations