Laser cut
IKEA Skadis tray
By Byteworks
A boxy open tray whose two rectangular side walls are hooked brackets for an IKEA Skadis board, with finger-jointed bottom and front and a back wall between them.
Prompt that made this
Ikea skådis tray
Made in Voloom from the prompt under the model. Download the cut sheets as they are, or fork a copy to change the material thickness and every size on the right — the joints re-cut to fit, without spending credits.
Make it fit your stock
Measure your sheet first. In the editor, set the thickness to match and every slot and tab re-cuts to fit. Change the sheet size and the parts nest again. Neither spends credits.
Download an SVG per sheet and send it to your laser cutter.
More to make
ModelForkCommunity
IKEA Skådis screwdriver holder
Two-piece IKEA Skådis screwdriver holder for printing, now stood upright as it hangs: a vertical back plate with four rounded J-pegs and two swept supports f…
ModelForkskadis bin
IKEA Skadis bin
A bin that hooks straight into your Skadis board with no clips. Three cells wide to start, 120 mm, with a curved front so you can reach in.
LaserForkLaser cut
Skådis thread spools holder
Hang-on comb plates for an IKEA Skadis board; each plate has hooks that drop into the pegboard slots and sloped blade pegs with rounded corners that carry th…
ModelForkCommunity
IKEA Skådis modem cradle for coda56
IKEA Skådis hook bracket: a 5 mm back plate with eight drop-in hooks, a 173 mm wide open-top cradle for a Hitron CODA 56 modem, and two diagonal corner lips…
LaserForkLaser cut
IKEA Skådis bin
An open tray on two hooked side brackets that hang on an IKEA Skadis board, with a floor, a front wall and a back wall.
ModelForkCommunity
IKEA Skådis spray can holder
IKEA Skådis spray-can holder, shown standing upright: a back plate as wide as the semicircles' straight side, with two J-pegs on the wall side. A semicircula…