IKEA Skådis spray can holder

By Byteworks

IKEA Skådis spray-can holder, shown standing upright: a back plate as wide as the semicircles' straight side, with two J-pegs on the wall side. A semicircular guide ring sits at the top and a semicircular floor with a centring rim sits far below. The plate ends at the floor.

Model
stl3mfstepobjglbbrep
Customize for free
IKEA Skådis spray can holder, 3D printable model

Prompt that made this

IKEA Skadis spray-can holder. A 70 mm ID ring 18 mm tall on a two-peg back plate, 2.4 mm walls.

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Hanging a spray can upright on an IKEA Skådis pegboard

The two pegs on the wall side drop into the board slots and carry the load. The can stands on the low semicircular floor, held centred by the rim, and leans into the open semicircular top guide. The back plate is as wide as the diameter of the semicircles and ends at the floor. The model stands upright, with the plate vertical.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • IKEA Skådis bin, 3D printable modelModelFork

    skadis bin

    IKEA Skadis bin

    A bin that hooks straight into your Skadis board with no clips. Three cells wide to start, 120 mm, with a curved front so you can reach in.

  • IKEA Skådis hook, 3D printable modelModelFork

    Community

    IKEA Skådis hook

    IKEA Skådis pegboard hook: two 5 mm pegs on 40 mm centres, a 4 mm back plate and a 12 mm wide J-hook projecting 35 mm, with an optional second hook 20 mm lower.

  • IKEA Skådis organizer tray with dividers, laser-cut designLaserFork

    Laser cut

    IKEA Skådis organizer tray with dividers

    Shorter open tray with dividers, hung on a Skadis board by two hooked side brackets that curve down to a low front.

  • IKEA Skådis tray, 3D printable modelModelFork

    Community

    IKEA Skådis tray

    Open-top wall tray, 120x70x40 mm inside with 1.6 mm walls, two IKEA Skådis hook pegs on 40 mm centres, a 3x3 grid of 4 mm drain holes and an optional centre…

  • IKEA Skadis tray, laser-cut designLaserFork

    Laser cut

    IKEA Skadis tray

    A boxy open tray whose two rectangular side walls are hooked brackets for an IKEA Skadis board, with finger-jointed bottom and front and a back wall between…

  • IKEA Skådis headphone holder, 3D printable modelModelFork

    Community

    IKEA Skådis headphone holder

    IKEA Skådis headphone holder: two pegs on 40 mm centres, a 90 mm wide R55 U-cradle with 3 mm walls and 6 mm lips, and an optional side cable hook.

Browse creations