IKEA Skådis tray

By Byteworks

Open-top wall tray, 120x70x40 mm inside with 1.6 mm walls, two IKEA Skådis hook pegs on 40 mm centres, a 3x3 grid of 4 mm drain holes and an optional centre divider.

Model
stlstepglb
Customize for free
IKEA Skådis tray, 3D printable model

Prompt that made this

IKEA Skadis wall tray, 120 × 70 × 40 mm inside, 1.6 mm walls, two Skadis pegs on 40 mm centres. Optional centre divider. Drain holes 4 mm in the floor, 3 × 3 grid.

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Small-parts tray hung on an IKEA Skådis pegboard

Two pegs pass through the board slots 40 mm apart and the hooks drop behind the board, so the tray hangs from the pegs. The floor drains through nine 4 mm holes. An optional divider splits the tray into left and right compartments.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • IKEA Skådis bin, 3D printable modelModelFork

    skadis bin

    IKEA Skadis bin

    A bin that hooks straight into your Skadis board with no clips. Three cells wide to start, 120 mm, with a curved front so you can reach in.

  • IKEA Skadis tray, laser-cut designLaserFork

    Laser cut

    IKEA Skadis tray

    A boxy open tray whose two rectangular side walls are hooked brackets for an IKEA Skadis board, with finger-jointed bottom and front and a back wall between…

  • IKEA Skådis modem cradle for coda56, 3D printable modelModelFork

    Community

    IKEA Skådis modem cradle for coda56

    IKEA Skådis hook bracket: a 5 mm back plate with eight drop-in hooks, a 173 mm wide open-top cradle for a Hitron CODA 56 modem, and two diagonal corner lips…

  • IKEA Skådis bin, laser-cut designLaserFork

    Laser cut

    IKEA Skådis bin

    An open tray on two hooked side brackets that hang on an IKEA Skadis board, with a floor, a front wall and a back wall.

  • IKEA Skådis spray can holder, 3D printable modelModelFork

    Community

    IKEA Skådis spray can holder

    IKEA Skådis spray-can holder, shown standing upright: a back plate as wide as the semicircles' straight side, with two J-pegs on the wall side. A semicircula…

  • IKEA Skådis organizer tray with dividers, laser-cut designLaserFork

    Laser cut

    IKEA Skådis organizer tray with dividers

    Shorter open tray with dividers, hung on a Skadis board by two hooked side brackets that curve down to a low front.

Browse creations