IKEA Skådis bin

By Byteworks

An open tray on two hooked side brackets that hang on an IKEA Skadis board, with a back wall, a lower front wall and a bottom tabbed between the brackets.

Laser
svg
Customize for free
IKEA Skådis bin, laser-cut design

Cut settings: 3 mm birch plywood · 600 × 400 · 1 sheet · 2.1 m of cut

Prompt that made this

Ikea skadis tray

Open the model

Made in Voloom from the prompt under the model. Download the cut sheets as they are, or fork a copy to change the material thickness and every size on the right — the joints re-cut to fit, without spending credits.

Make it fit your stock

Measure your sheet first. In the editor, set the thickness to match and every slot and tab re-cuts to fit. Change the sheet size and the parts nest again. Neither spends credits.

Download an SVG per sheet and send it to your laser cutter.

More to make

  • IKEA Skådis organizer tray with dividers, laser-cut designLaserFork

    Laser cut

    IKEA Skådis organizer tray with dividers

    Shorter open tray with dividers, hung on a Skadis board by two hooked side brackets that curve down to a low front.

  • IKEA Skådis bin, 3D printable modelModelFork

    skadis bin

    IKEA Skadis bin

    A bin that hooks straight into your Skadis board with no clips. Three cells wide to start, 120 mm, with a curved front so you can reach in.

  • IKEA Skådis cable hook, 3D printable modelModelFork

    Community

    IKEA Skådis cable hook

    IKEA Skådis pegboard cable hook with a 4 mm back plate, two drop-in pegs on 40 mm centres, and three 8 mm wide J-hooks in a vertical row 18 mm apart.

  • Skådis thread spools holder, laser-cut designLaserFork

    Laser cut

    Skådis thread spools holder

    Hang-on comb plates for an IKEA Skadis board; each plate has hooks that drop into the pegboard slots and sloped blade pegs with rounded corners that carry th…

  • IKEA Skådis tray, 3D printable modelModelFork

    Community

    IKEA Skådis tray

    Open-top wall tray, 120x70x40 mm inside with 1.6 mm walls, two IKEA Skådis hook pegs on 40 mm centres, a 3x3 grid of 4 mm drain holes and an optional centre…

  • IKEA Skådis phone holder, 3D printable modelModelFork

    Community

    IKEA Skådis phone holder

    IKEA Skådis pegboard phone holder with two hook pegs on 40 mm centres and a tilted 78 x 18 mm phone slot at 65 degrees with a 6 mm front lip and an 8 mm cabl…

Browse creations