IKEA Skådis cable hook

By Byteworks

IKEA Skådis pegboard cable hook with a 4 mm back plate, two drop-in pegs on 40 mm centres, and three 8 mm wide J-hooks in a vertical row 18 mm apart.

Model
stlstepglb
Customize for free
IKEA Skådis cable hook, 3D printable model

Prompt that made this

IKEA Skadis cable hook. Two pegs, three 8 mm J-hooks in a vertical row 18 mm apart, 4 mm thick.

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Hanging charging or power cables from an IKEA Skådis pegboard

The two pegs drop into Skadis slots and carry the load through the back plate. Each J-hook cradles a cable in its upturned tip on the room side.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • IKEA Skådis bin, 3D printable modelModelFork

    skadis bin

    IKEA Skadis bin

    A bin that hooks straight into your Skadis board with no clips. Three cells wide to start, 120 mm, with a curved front so you can reach in.

  • Skådis thread spools holder, laser-cut designLaserFork

    Laser cut

    Skådis thread spools holder

    Hang-on comb plates for an IKEA Skadis board; each plate has hooks that drop into the pegboard slots and sloped blade pegs with rounded corners that carry th…

  • IKEA Skådis headphone holder, 3D printable modelModelFork

    Community

    IKEA Skådis headphone holder

    IKEA Skådis headphone holder: two pegs on 40 mm centres, a 90 mm wide R55 U-cradle with 3 mm walls and 6 mm lips, and an optional side cable hook.

  • IKEA Skådis organizer tray with dividers, laser-cut designLaserFork

    Laser cut

    IKEA Skådis organizer tray with dividers

    Shorter open tray with dividers, hung on a Skadis board by two hooked side brackets that curve down to a low front.

  • IKEA Skådis spray can holder, 3D printable modelModelFork

    Community

    IKEA Skådis spray can holder

    IKEA Skådis spray-can holder, shown standing upright: a back plate as wide as the semicircles' straight side, with two J-pegs on the wall side. A semicircula…

  • IKEA Skadis tray, laser-cut designLaserFork

    Laser cut

    IKEA Skadis tray

    A boxy open tray whose two rectangular side walls are hooked brackets for an IKEA Skadis board, with finger-jointed bottom and front and a back wall between…

Browse creations