IKEA Skådis screwdriver holder

By Byteworks

Two-piece IKEA Skådis screwdriver holder for printing, now stood upright as it hangs: a vertical back plate with four rounded J-pegs and two swept supports forming a tight channel, and a separate horizontal block with twelve 8 mm holes whose tongue slots in from the front. One vertical screw joins the parts.

Model
stl3mfstepobjglbbrep
Customize for free
IKEA Skådis screwdriver holder, 3D printable model

Prompt that made this

IKEA Skadis screwdriver holder. Two pegs on 40 mm centres, a 120 × 24 × 18 mm block with eight 8 mm holes through, 18 mm apart.

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Hanging screwdrivers and similar shafts on an IKEA Skådis pegboard, printed as two parts

Four J-pegs, two columns of two on 40 mm centres, drop into board holes and carry the thin upright back plate. Two swept supports on the plate form a tight channel with a pocket in the plate. The separate block slides in horizontally from the front and its tongue seats in the pocket. A vertical screw runs from the top through the upper support, the block and the lower support, locking the two parts together. Each tool shaft passes down through one hole with its handle resting on top of the block.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • IKEA Skådis bin, 3D printable modelModelFork

    skadis bin

    IKEA Skadis bin

    A bin that hooks straight into your Skadis board with no clips. Three cells wide to start, 120 mm, with a curved front so you can reach in.

  • IKEA Skådis bin, laser-cut designLaserFork

    Laser cut

    IKEA Skådis bin

    An open tray on two hooked side brackets that hang on an IKEA Skadis board, with a floor, a front wall and a back wall.

  • IKEA Skadis tray, laser-cut designLaserFork

    Laser cut

    IKEA Skadis tray

    A boxy open tray whose two rectangular side walls are hooked brackets for an IKEA Skadis board, with finger-jointed bottom and front and a back wall between…

  • IKEA Skådis hook, 3D printable modelModelFork

    Community

    IKEA Skådis hook

    IKEA Skådis pegboard hook: two 5 mm pegs on 40 mm centres, a 4 mm back plate and a 12 mm wide J-hook projecting 35 mm, with an optional second hook 20 mm lower.

  • IKEA Skådis organizer tray with dividers, laser-cut designLaserFork

    Laser cut

    IKEA Skådis organizer tray with dividers

    Shorter open tray with dividers, hung on a Skadis board by two hooked side brackets that curve down to a low front.

  • IKEA Skådis headphone holder, 3D printable modelModelFork

    Community

    IKEA Skådis headphone holder

    IKEA Skådis headphone holder: two pegs on 40 mm centres, a 90 mm wide R55 U-cradle with 3 mm walls and 6 mm lips, and an optional side cable hook.

Browse creations