Raspberry pi 5 case

By Byteworks

Two-part Raspberry Pi 5 case sized to the 85x56 mm board: a deep, hollow, rounded-corner base with a 2.5 mm floor, four tubular standoffs, clearly cut port openings (Ethernet, two USB stacks, USB-C, two micro-HDMI, microSD, GPIO) and floor vents, plus a separate lid with through-cut vent slots and a hollow locating lip.

Model
stlstepglb
Customize for free
Raspberry pi 5 case, 3D printable model

Prompt that made this

Raspberry pi 5 case

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Protecting and mounting a Raspberry Pi 5 (85x56 mm board) on a desk or shelf

The board sits on four standoffs on the 58x49 mm hole pattern inside a deep walled, open-topped cavity with separate openings for Ethernet, both USB stacks, USB-C, two micro-HDMI, microSD and GPIO; the lid lip drops into the cavity and the lid slots let heat out.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • Rover chassis, 3D printable modelModelFork

    Community

    Rover chassis

    3D-printable four-motor rover chassis: a 180x120x4 plate with four half-saddles at the corners, BTS7960 and ESP32 standoff pads, a 150x60 battery tray with s…

  • Arduino nano case, 3D printable modelModelFork

    Community

    Arduino nano case

    Two-part Arduino Nano case shown assembled: the snap-on lid sits closed on the base with its lip inside the cavity. The base has a USB end cut-out and side s…

  • Raspberry Pi Zero case, 3D printable modelModelFork

    Community

    Raspberry Pi Zero case

    Two-part Raspberry Pi Zero case shown assembled: the lid is flipped and seated on the open-top base, with its rim inside the cavity and its snap bumps in the…

  • Arduino Uno Q case, 3D printable modelModelFork

    Community

    Arduino Uno Q case

    Two-part enclosure for the Arduino UNO Q (Uno form factor, 68.6 x 53.3 mm): a base tray with four standoffs and a USB-C opening, plus a lid with a locating l…

  • Project box, 3D printable modelModelFork

    Community

    Project box

    Project enclosure sized for a standard full-size breadboard (165x55 mm) with 4 screw posts, an optional end port cutout and an optional separate screw-down l…

  • Esp32 38pin snap enclosure, 3D printable modelModelFork

    Community

    Esp32 38pin snap enclosure

    Two-part snap-fit case for a 38-pin ESP32 dev board, with rounded outer vertical corners, a USB-C end opening, an optional vented lid and a lid lip with sphe…

Browse creations