Esp32 38pin snap enclosure

By Byteworks

Two-part snap-fit case for a 38-pin ESP32 dev board, with rounded outer vertical corners, a USB-C end opening, an optional vented lid and a lid lip with sphere-capped catches that engage windows in the base walls.

Model
stl3mfstepobjglbbrep
Customize for free
Esp32 38pin snap enclosure, 3D printable model

Prompt that made this

ESP32-WROOM-32 Enclosure USB-C 38 Pin Wide ESP32 Dev Board Case Snap-Fit Protective Box

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Protective desktop enclosure for an ESP32-WROOM-32 38-pin dev board that is plugged in through USB-C.

The board rests on two end ledges, so the header pins hang free under it. The USB-C connector lines up with a rectangular opening in the end wall. The lid lip drops into the base cavity and its two hemispherical bumps click into the windows in the long walls.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • Arduino uno snap case, 3D printable modelModelFork

    Community

    Arduino uno snap case

    Two-piece Arduino UNO enclosure shown assembled: a base with board standoffs, USB and DC jack cutouts, snap windows and a raised text label on the right side…

  • Heltec v3 meshtastic case, 3D printable modelModelFork

    Community

    Heltec v3 meshtastic case

    Two-part Heltec WiFi LoRa 32 V3 Meshtastic case shown assembled, sized to the real 50.8 x 25.4 mm board. Posts sit between the two pin-header rows, the USB-C…

  • Raspberry Pi 5 snap fit case, 3D printable modelModelFork

    Community

    Raspberry Pi 5 snap fit case

    Two parts: a base with standoffs and port cutouts, and a snap-fit lid with an engraved ring and logo. The back wall carries engraved text.

  • Arduino nano case, 3D printable modelModelFork

    Community

    Arduino nano case

    Two-part Arduino Nano case shown assembled: the snap-on lid sits closed on the base with its lip inside the cavity. The base has a USB end cut-out and side s…

  • Raspberry Pi Zero case, 3D printable modelModelFork

    Community

    Raspberry Pi Zero case

    Two-part Raspberry Pi Zero case shown assembled: the lid is flipped and seated on the open-top base, with its rim inside the cavity and its snap bumps in the…

  • Rover chassis, 3D printable modelModelFork

    Community

    Rover chassis

    3D-printable four-motor rover chassis: a 180x120x4 plate with four half-saddles at the corners, BTS7960 and ESP32 standoff pads, a 150x60 battery tray with s…

Browse creations