Raspberry Pi 5 snap fit case

By Byteworks

Two-part Raspberry Pi 5 case: a base with standoffs and port cutouts, and a snap-fit lid with an engraved ring and a logo turned 90 degrees. The back wall carries engraved text.

Model
stl3mfstepobjglbbrep
Customize for free
Raspberry Pi 5 snap fit case, 3D printable model

Prompt that made this

Raspberry Pi 5 case with standoffs, port cutouts and a snap-fit lid; the base and lid have rounded vertical corners and softened top and bottom outer edges, with the lid's edge softness limited to its 3 mm thickness. The lid carries the uploaded logo engraved inside a ring, and 'YOUR TEXT' is engraved along the back side, which has no ports.

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Protective enclosure for a Raspberry Pi 5 (85 x 56 mm board) that can be 3D printed

The Pi sits on four standoffs on the 58x49 hole pattern. Its ports show through wall cutouts. The lid's hollow lip drops into the cavity and its sphere bumps click into windows in the base walls.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • Project box, 3D printable modelModelFork

    Community

    Project box

    Project enclosure sized for a standard full-size breadboard (165x55 mm) with 4 screw posts, an optional end port cutout and an optional separate screw-down l…

  • Raspberry Pi 4 snap fit case, 3D printable modelModelFork

    Community

    Raspberry Pi 4 snap fit case

    Two parts: a base with standoffs and port cutouts, and a snap-fit lid with a logo engraved in a ring.

  • Arduino Uno Q case, 3D printable modelModelFork

    Community

    Arduino Uno Q case

    Two-part enclosure for the Arduino UNO Q (Uno form factor, 68.6 x 53.3 mm): a base tray with four standoffs and a USB-C opening, plus a lid with a locating l…

  • Heltec v3 meshtastic case, 3D printable modelModelFork

    Community

    Heltec v3 meshtastic case

    Two-part Heltec WiFi LoRa 32 V3 Meshtastic case shown assembled, sized to the real 50.8 x 25.4 mm board. Posts sit between the two pin-header rows, the USB-C…

  • Raspberry pi 5 case, 3D printable modelModelFork

    Community

    Raspberry pi 5 case

    Two-part Raspberry Pi 5 case sized to the 85x56 mm board: a deep, hollow, rounded-corner base with a 2.5 mm floor, four tubular standoffs, clearly cut port o…

  • Arduino uno snap case, 3D printable modelModelFork

    Community

    Arduino uno snap case

    Two-piece Arduino UNO enclosure shown assembled: a base with board standoffs, USB and DC jack cutouts, snap windows and a raised text label on the right side…

Browse creations