Arduino Uno Q case

By Byteworks

Two-part enclosure for the Arduino UNO Q (Uno form factor, 68.6 x 53.3 mm): a base tray with four standoffs and a USB-C opening, plus a lid with a locating lip and header slots.

Model
stl3mfstepobjglbbrep
Customize for free
Arduino Uno Q case, 3D printable model

Prompt that made this

Arduino UNO Q case (new board; reuses our Uno recipe)

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Desktop protective case for an Arduino UNO Q board, printed on an FDM printer

Board sits on four screw standoffs at the Uno-pattern hole positions inside the tray; the USB-C connector passes through the left wall; the lid lip locates inside the tray walls and slots expose the header rows.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • Raspberry pi 5 case, 3D printable modelModelFork

    Community

    Raspberry pi 5 case

    Two-part Raspberry Pi 5 case sized to the 85x56 mm board: a deep, hollow, rounded-corner base with a 2.5 mm floor, four tubular standoffs, clearly cut port o…

  • Raspberry Pi 4 snap fit case, 3D printable modelModelFork

    Community

    Raspberry Pi 4 snap fit case

    Two parts: a base with standoffs and port cutouts, and a snap-fit lid with a logo engraved in a ring.

  • Raspberry Pi 5 snap fit case, 3D printable modelModelFork

    Community

    Raspberry Pi 5 snap fit case

    Two parts: a base with standoffs and port cutouts, and a snap-fit lid with an engraved ring and logo. The back wall carries engraved text.

  • Arduino nano case, 3D printable modelModelFork

    Community

    Arduino nano case

    Two-part Arduino Nano case shown assembled: the snap-on lid sits closed on the base with its lip inside the cavity. The base has a USB end cut-out and side s…

  • Rover chassis, 3D printable modelModelFork

    Community

    Rover chassis

    3D-printable four-motor rover chassis: a 180x120x4 plate with four half-saddles at the corners, BTS7960 and ESP32 standoff pads, a 150x60 battery tray with s…

  • Raspberry Pi Zero case, 3D printable modelModelFork

    Community

    Raspberry Pi Zero case

    Two-part Raspberry Pi Zero case shown assembled: the lid is flipped and seated on the open-top base, with its rim inside the cavity and its snap bumps in the…

Browse creations