Arduino nano case

By Byteworks

Two-part Arduino Nano case shown assembled: the snap-on lid sits closed on the base with its lip inside the cavity. The base has a USB end cut-out and side slot rows for header pins, and the lid has a reset-button slot.

Model
stl3mfstepobjglbbrep
Customize for free
Arduino nano case, 3D printable model

Prompt that made this

Arduino Nano case. The board is 45 × 18 mm. A two-part case, base and snap-on lid as separate parts, with a cut-out for the mini USB port at one end, a slot in the lid above the reset button, and two rows of slots along the sides so header pins can come out. Walls 2 mm.

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Protective enclosure for an Arduino Nano (45 x 18 mm board) with USB, reset and header pin access, 3D printed on FDM.

The board sits on the base floor. The lid's thin lip drops into the cavity and its two bumps click into windows in the long walls. The USB cable passes through the end cut-out, the reset button is reached through the lid slot, and header pins can exit through the side slots.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • ESP32 project box, 3D printable modelModelFork

    Community

    ESP32 project box

    ESP32 DevKit project box with a USB-C cutout, four standoffs, optional cable gland holes on one short wall and a separate snap-fit lid.

  • Raspberry pi 5 case, 3D printable modelModelFork

    Community

    Raspberry pi 5 case

    Two-part Raspberry Pi 5 case sized to the 85x56 mm board: a deep, hollow, rounded-corner base with a 2.5 mm floor, four tubular standoffs, clearly cut port o…

  • Arduino uno snap case, 3D printable modelModelFork

    Community

    Arduino uno snap case

    Two-piece Arduino UNO enclosure shown assembled: a base with board standoffs, USB and DC jack cutouts, snap windows and a raised text label on the right side…

  • Heltec v3 meshtastic case, 3D printable modelModelFork

    Community

    Heltec v3 meshtastic case

    Two-part Heltec WiFi LoRa 32 V3 Meshtastic case shown assembled, sized to the real 50.8 x 25.4 mm board. Posts sit between the two pin-header rows, the USB-C…

  • Raspberry Pi 4 snap fit case, 3D printable modelModelFork

    Community

    Raspberry Pi 4 snap fit case

    Two parts: a base with standoffs and port cutouts, and a snap-fit lid with a logo engraved in a ring.

  • Raspberry Pi 5 snap fit case, 3D printable modelModelFork

    Community

    Raspberry Pi 5 snap fit case

    Two parts: a base with standoffs and port cutouts, and a snap-fit lid with an engraved ring and logo. The back wall carries engraved text.

Browse creations