Raspberry Pi Zero case

By Byteworks

Two-part Raspberry Pi Zero case shown assembled: the lid is flipped and seated on the open-top base, with its rim inside the cavity and its snap bumps in the base windows.

Model
stl3mfstepobjglbbrep
Customize for free
Raspberry Pi Zero case, 3D printable model

Prompt that made this

Raspberry Pi Zero case, 68 × 33 × 12 mm, 1.6 mm walls, mini-HDMI / USB / SD / 40-pin cutouts. Optional 8 mm camera hole in the lid. Separate lid on four 1.6 mm snaps.

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Protective enclosure for a Raspberry Pi Zero (65x30 mm board) that stays accessible through its ports

The board sits on four posts inside the base. The lid plate rests on the wall tops, its rim locates inside the cavity, and four snap bumps on the rim engage 1.6 mm windows in the long walls. Side cutouts expose mini-HDMI, two micro-USB ports and the SD card, and the lid window exposes the 40-pin header.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • Arduino Uno Q case, 3D printable modelModelFork

    Community

    Arduino Uno Q case

    Two-part enclosure for the Arduino UNO Q (Uno form factor, 68.6 x 53.3 mm): a base tray with four standoffs and a USB-C opening, plus a lid with a locating l…

  • ESP32 project box, 3D printable modelModelFork

    Community

    ESP32 project box

    ESP32 DevKit project box with a USB-C cutout, four standoffs, optional cable gland holes on one short wall and a separate snap-fit lid.

  • Esp32 38pin snap enclosure, 3D printable modelModelFork

    Community

    Esp32 38pin snap enclosure

    Two-part snap-fit case for a 38-pin ESP32 dev board, with rounded outer vertical corners, a USB-C end opening, an optional vented lid and a lid lip with sphe…

  • Raspberry pi 5 case, 3D printable modelModelFork

    Community

    Raspberry pi 5 case

    Two-part Raspberry Pi 5 case sized to the 85x56 mm board: a deep, hollow, rounded-corner base with a 2.5 mm floor, four tubular standoffs, clearly cut port o…

  • Arduino uno snap case, 3D printable modelModelFork

    Community

    Arduino uno snap case

    Two-piece Arduino UNO enclosure shown assembled: a base with board standoffs, USB and DC jack cutouts, snap windows and a raised text label on the right side…

  • Project box, 3D printable modelModelFork

    Community

    Project box

    Project enclosure sized for a standard full-size breadboard (165x55 mm) with 4 screw posts, an optional end port cutout and an optional separate screw-down l…

Browse creations