Project box

By Byteworks

Project enclosure sized for a standard full-size breadboard (165x55 mm) with 4 screw posts, an optional end port cutout and an optional separate screw-down lid with a perimeter lip that seats inside the walls. The lid is laid out shut on the wall tops with its lip dropped into the cavity. The lid's outer edges are softened with a small fillet. If you meant a different 'standard size', change the stock size parameters.

Model
stlstepglb
Customize for free
Project box, 3D printable model

Prompt that made this

Breadcrumb standard size project box

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Housing for a full-size breadboard or a similar electronics project

An open-top tray holds the board inside walls. Four corner posts take M2.5 self-tapping screws that pass through the lid. The lid's perimeter lip drops inside the walls so it locates and seats flush on the wall tops. An optional wall cutout gives cable or USB access.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • Arduino Uno Q case, 3D printable modelModelFork

    Community

    Arduino Uno Q case

    Two-part enclosure for the Arduino UNO Q (Uno form factor, 68.6 x 53.3 mm): a base tray with four standoffs and a USB-C opening, plus a lid with a locating l…

  • ESP32 project box, 3D printable modelModelFork

    Community

    ESP32 project box

    ESP32 DevKit project box with a USB-C cutout, four standoffs, optional cable gland holes on one short wall and a separate snap-fit lid.

  • Raspberry Pi 5 snap fit case, 3D printable modelModelFork

    Community

    Raspberry Pi 5 snap fit case

    Two parts: a base with standoffs and port cutouts, and a snap-fit lid with an engraved ring and logo. The back wall carries engraved text.

  • Arduino nano case, 3D printable modelModelFork

    Community

    Arduino nano case

    Two-part Arduino Nano case shown assembled: the snap-on lid sits closed on the base with its lip inside the cavity. The base has a USB end cut-out and side s…

  • Esp32 38pin snap enclosure, 3D printable modelModelFork

    Community

    Esp32 38pin snap enclosure

    Two-part snap-fit case for a 38-pin ESP32 dev board, with rounded outer vertical corners, a USB-C end opening, an optional vented lid and a lid lip with sphe…

  • Raspberry pi 5 case, 3D printable modelModelFork

    Community

    Raspberry pi 5 case

    Two-part Raspberry Pi 5 case sized to the 85x56 mm board: a deep, hollow, rounded-corner base with a 2.5 mm floor, four tubular standoffs, clearly cut port o…

Browse creations