3D print
Prompt that made this
IKEA Skadis shelf, 160 × 80 × 4 mm plate, two pegs on 80 mm centres (two holes apart), 16 mm rear riser. Optional 8 mm front fence.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Small shelf hung on an IKEA Skådis pegboard to hold tools or boxes
Two J-hook pegs pass through Skadis slots and drop behind the board. The rear riser stiffens the peg joint and stops items sliding back. The two mounting holes sit on the same 80 mm centres as the pegs. The optional fence stops items sliding off the front.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
ModelForkskadis bin
IKEA Skadis bin
A bin that hooks straight into your Skadis board with no clips. Three cells wide to start, 120 mm, with a curved front so you can reach in.
LaserForkLaser cut
IKEA Skadis tray
A boxy open tray whose two rectangular side walls are hooked brackets for an IKEA Skadis board, with finger-jointed bottom and front and a back wall between…
ModelForkCommunity
IKEA Skådis cable hook
IKEA Skådis pegboard cable hook with a 4 mm back plate, two drop-in pegs on 40 mm centres, and three 8 mm wide J-hooks in a vertical row 18 mm apart.
LaserForkLaser cut
IKEA Skådis organizer tray with dividers
Shorter open tray with dividers, hung on a Skadis board by two hooked side brackets that curve down to a low front.
ModelForkCommunity
IKEA Skådis headphone holder
IKEA Skådis headphone holder: two pegs on 40 mm centres, a 90 mm wide R55 U-cradle with 3 mm walls and 6 mm lips, and an optional side cable hook.
LaserForkLaser cut
Skådis thread spools holder
Hang-on comb plates for an IKEA Skadis board; each plate has hooks that drop into the pegboard slots and sloped blade pegs with rounded corners that carry th…