Laser cut
Finger jointed desktop organizer
By Byteworks
Finger-jointed desktop organizer with a front-open carcass, two tabbed shelves and three open-top drawers, each with a finger-pull slot.
Prompt that made this
A 3 level drawer organizer finger jointed
Made in Voloom from the prompt under the model. Download the cut sheets as they are, or fork a copy to change the material thickness and every size on the right — the joints re-cut to fit, without spending credits.
Make it fit your stock
Measure your sheet first. In the editor, set the thickness to match and every slot and tab re-cuts to fit. Change the sheet size and the parts nest again. Neither spends credits.
Download an SVG per sheet and send it to your laser cutter.
More to make
LaserForklaser cut organizer
Laser cut desk organizer
Laser cut desk organizer as a parametric cut file. Set the stock and size, then download the SVG or DXF.
CNCForkcnc box
CNC box with lid
CNC box with lid as a parametric cut file. Set the stock and size, then download the SVG or DXF.
ModelForkCommunity
Toothbrush holder
Hollow toothbrush cup with an 8 mm floor drain and a separate drop-in insert with four 12 mm brush holes.
LaserForkhouse number sign
House number sign
House number sign as a parametric cut file. Set the stock and size, then download the SVG or DXF.
CNCForkCNC cut
Drawer cabinet
Finger-jointed carcass with a back and two tabbed shelves, holding three sliding finger-jointed drawers with hand slots.
ModelForkCommunity
Coffee pod holder
Rectangular coffee-pod tray with a 4 x 3 grid of round 38 mm pockets, 16 mm deep, separated by 1.6 mm walls, on a 1.6 mm floor.