3D print
Prompt that made this
Toothbrush holder. A 70 mm cup 80 mm tall and a separate 4-hole insert (12 mm holes) that drops in. Drain hole 8 mm in the floor.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Bathroom toothbrush holder holding four brushes.
The insert drops into the open cup and stands on a short skirt above the floor. Brush handles go in the four holes, and water runs through the holes and under the insert to the center drain.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
LaserForkLaser cut
Pitched roof birdhouse
Finger-jointed birdhouse with a front-overhanging pitched roof, a 32 mm entrance hole, a flat perch with a rounded end, and a tall back plate with a hanging…
ModelForkCommunity
Controller stand
Two-piece game-controller stand: a 90x70 base plate and a separate 70 mm-wide saddle with an 18 mm channel, leaned back 12 degrees and resting on the base.
CNCForkCNC cut
Workstation desk
A wide flat-pack desk on two tapered, splayed inverted-U leg frames with the desk top resting between them, an upper bracket pressed against the underside of…
LaserForkLaser cut
Glueless desk organizer
Open-top desk tray with finger-jointed walls and two crossing dividers; every joint is a mechanical finger, tab or cross-slot, so it assembles without glue.
ModelForkCommunity
Bike wall hook
Wall-mounted bike hook: a vertical 40x90x8 back plate with two countersunk 5 mm screw holes 60 mm apart, a rounded J-shaped arm 30 wide that projects 110 mm…
