Pitched roof birdhouse

By Byteworks

Finger-jointed birdhouse with a front-overhanging pitched roof, a 32 mm entrance hole, a flat perch with a rounded end, and a tall back plate with a hanging hole.

Laser
svg
Customize for free
Pitched roof birdhouse, laser-cut design

Cut settings: 6 mm birch plywood · 600 × 400 · 1 sheet · 4.9 m of cut

Prompt that made this

A birdhouse with a pitched roof that overhangs the front, a 32 mm entrance hole, a round perch below it, and a back panel that extends up to hang it on a wall. Finger-jointed, about 160 mm tall.

Open the model

Made in Voloom from the prompt under the model. Download the cut sheets as they are, or fork a copy to change the material thickness and every size on the right — the joints re-cut to fit, without spending credits.

Make it fit your stock

Measure your sheet first. In the editor, set the thickness to match and every slot and tab re-cuts to fit. Change the sheet size and the parts nest again. Neither spends credits.

Download an SVG per sheet and send it to your laser cutter.

More to make

  • Laser cut toy roadster, laser-cut designLaserFork

    Laser cut

    Laser cut toy roadster

    Thirteen parts cut from 3 mm birch plywood: a chassis, axle bars, four wheels, body sides, a seat back, a windshield, and grille and tail plates.

  • Castle dice tower, 3D printable modelModelFork

    Community

    Castle dice tower

    Castle-style dice tower: four round corner turrets, battlements (merlons) around the open top and arrow-slit windows, with the same internal baffles, front e…

  • A stool, CNC designCNCFork

    CNC cut

    A stool

    Round plywood stool: a disc seat held by two interlocking leg frames whose legs splay outward, tabbed up through the seat.

  • Round lantern, laser-cut designLaserFork

    Laser cut

    Round lantern

    A two-storey round lantern with a double candle door (two leaves, each hinged on top and bottom pins at its outer side), a diamond cross-hatch lattice with s…

  • Rover chassis, 3D printable modelModelFork

    Community

    Rover chassis

    3D-printable four-motor rover chassis: a 180x120x4 plate with four half-saddles at the corners, BTS7960 and ESP32 standoff pads, a 150x60 battery tray with s…

  • Lidded box, CNC designCNCFork

    cnc box

    CNC box with lid

    CNC box with lid as a parametric cut file. Set the stock and size, then download the SVG or DXF.

Browse creations