Castle dice tower

By Byteworks

Castle-style dice tower: four round corner turrets, battlements (merlons) around the open top and arrow-slit windows, with the same internal baffles, front exit and rimmed tray.

Model
stl3mfstepobjglbbrep
Customize for free
Castle dice tower, 3D printable model

Prompt that made this

Dice tower for board games. A 70 × 70 mm square tower 160 mm tall, open at the top, with three angled baffles inside so dice tumble down, an opening at the front bottom onto a tray 100 mm long with a 15 mm rim. Walls 3 mm thick.

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Rolling dice for board games so they tumble and land randomly, with a castle look

Dice are dropped in the open top between the battlements, bounce down three alternating sloped baffles, fall to the floor and slide out of the front opening onto the rimmed tray.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • Treasure chest, 3D printable modelModelFork

    Community

    Treasure chest

    Treasure chest with a hollow base, a barrel-vault hollow lid, metal straps, and a lock plate with a hasp.

  • House model, laser-cut designLaserFork

    Laser cut

    House model

    Flat-pack house with a tall gabled main block, a lower gabled side wing, an arched six-pane window, ventilation holes, engraved doors and a four-panel chimne…

  • Three arm fidget spinner, 3D printable modelModelFork

    Community

    Three arm fidget spinner

    Three-arm fidget spinner, 7 mm thick, 75 mm tip to tip, shown assembled: two 22 mm finger caps sit on either face of the centre bearing seat and screw into e…

  • Pitched roof birdhouse, laser-cut designLaserFork

    Laser cut

    Pitched roof birdhouse

    Finger-jointed birdhouse with a front-overhanging pitched roof, a 32 mm entrance hole, a flat perch with a rounded end, and a tall back plate with a hanging…

  • Rover chassis, 3D printable modelModelFork

    Community

    Rover chassis

    3D-printable four-motor rover chassis: a 180x120x4 plate with four half-saddles at the corners, BTS7960 and ESP32 standoff pads, a 150x60 battery tray with s…

  • Duomo di Milano, laser-cut designLaserFork

    Laser cut

    Duomo di Milano

    Flat-pack model of Milan Cathedral: a finger-jointed nave with a portalled facade, a stepped gable, two rows of pinnacles and a tall crossed central spire.

Browse creations