Laser cut
House model
By Byteworks
Flat-pack house with a tall gabled main block, a lower gabled side wing, an arched six-pane window, ventilation holes, engraved doors and a four-panel chimney on the main roof, standing on a base plate.
Prompt that made this
Replicate the reference image
Made in Voloom from the prompt under the model. Download the cut sheets as they are, or fork a copy to change the material thickness and every size on the right — the joints re-cut to fit, without spending credits.
Make it fit your stock
Measure your sheet first. In the editor, set the thickness to match and every slot and tab re-cuts to fit. Change the sheet size and the parts nest again. Neither spends credits.
Download an SVG per sheet and send it to your laser cutter.
More to make
LaserForkLaser cut
Pitched roof birdhouse
Finger-jointed birdhouse with a front-overhanging pitched roof, a 32 mm entrance hole, a flat perch with a rounded end, and a tall back plate with a hanging…
ModelForkCommunity
Three arm fidget spinner
Three-arm fidget spinner, 7 mm thick, 75 mm tip to tip, shown assembled: two 22 mm finger caps sit on either face of the centre bearing seat and screw into e…
LaserForkLaser cut
Eiffel tower
Eiffel tower with real proportions: platforms at 17% and 35% of the height, a slender concave profile, an arched first section, a top deck at 84% and a taper…
ModelForkCommunity
Pipped die
A 22 mm die with 3 mm rounded edges and 1 to 6 recessed pips per face, each 0.8 mm deep.
ModelForkCommunity
Castle dice tower
Castle-style dice tower: four round corner turrets, battlements (merlons) around the open top and arrow-slit windows, with the same internal baffles, front e…
LaserForkLaser cut
Laser cut toy roadster
Thirteen parts cut from 3 mm birch plywood: a chassis, axle bars, four wheels, body sides, a seat back, a windshield, and grille and tail plates.