Laser cut
Laser cut toy roadster
By Byteworks
Push-along open roadster with a chassis, axle bars, four wheels, two body sides, a seat back and, new, a windshield frame, a grille plate with headlights and a tail plate with taillights.
Prompt that made this
A toy car
Made in Voloom from the prompt under the model. Download the cut sheets as they are, or fork a copy to change the material thickness and every size on the right — the joints re-cut to fit, without spending credits.
Make it fit your stock
Measure your sheet first. In the editor, set the thickness to match and every slot and tab re-cuts to fit. Change the sheet size and the parts nest again. Neither spends credits.
Download an SVG per sheet and send it to your laser cutter.
More to make
ModelForkCommunity
Castle dice tower
Castle-style dice tower: four round corner turrets, battlements (merlons) around the open top and arrow-slit windows, with the same internal baffles, front e…
LaserForkLaser cut
Pitched roof birdhouse
Finger-jointed birdhouse with a front-overhanging pitched roof, a 32 mm entrance hole, a flat perch with a rounded end, and a tall back plate with a hanging…
ModelForkCommunity
Three arm fidget spinner
Three-arm fidget spinner, 7 mm thick, 75 mm tip to tip, shown assembled: two 22 mm finger caps sit on either face of the centre bearing seat and screw into e…
LaserForkLaser cut
Duomo di Milano
Flat-pack model of Milan Cathedral: a finger-jointed nave with a portalled facade, a stepped gable, two rows of pinnacles and a tall crossed central spire.
ModelForkCommunity
Pipped die
A 22 mm die with 3 mm rounded edges and 1 to 6 recessed pips per face, each 0.8 mm deep.
LaserForkLaser cut
House model
Flat-pack house with a tall gabled main block, a lower gabled side wing, an arched six-pane window, ventilation holes, engraved doors and a four-panel chimne…