Laser cut
Round lantern
By Byteworks
A two-storey round lantern with a candle door pivoting on top and bottom pins in the lower storey, and a crossed-rib cupola dome on top.
Prompt that made this
Round lantern
Made in Voloom from the prompt under the model. Download the cut sheets as they are, or fork a copy to change the material thickness and every size on the right — the joints re-cut to fit, without spending credits.
Make it fit your stock
Measure your sheet first. In the editor, set the thickness to match and every slot and tab re-cuts to fit. Change the sheet size and the parts nest again. Neither spends credits.
Download an SVG per sheet and send it to your laser cutter.
More to make
LaserForkLaser cut
Pitched roof birdhouse
Finger-jointed birdhouse with a front-overhanging pitched roof, a 32 mm entrance hole, a flat perch with a rounded end, and a tall back plate with a hanging…
ModelForkCommunity
Cable comb
Flat cable comb with eight open-top slots and optional mounting holes at each end.
CNCForkCNC cut
Workstation desk
A wide flat-pack desk on two tapered, splayed inverted-U leg frames with the desk top resting between them, an upper bracket pressed against the underside of…
LaserForkLaser cut
Cross leg stool
Round stool with two cross-slotted X legs, a ring at the feet tying them together, and a round seat tabbed into the leg tops.
CNCForkCNC cut
Chair - Rounded
A taller, sleeker flat-pack chair with tapered side frames and a backrest reclined at an angle: the front legs splay forward and narrow toward the foot, and…
