Laser cut
Glueless desk organizer
By Byteworks
Open-top desk tray with finger-jointed walls and two crossing dividers; every joint is a mechanical finger, tab or cross-slot, so it assembles without glue.
Prompt that made this
Glueless desk organizer
Made in Voloom from the prompt under the model. Download the cut sheets as they are, or fork a copy to change the material thickness and every size on the right — the joints re-cut to fit, without spending credits.
Make it fit your stock
Measure your sheet first. In the editor, set the thickness to match and every slot and tab re-cuts to fit. Change the sheet size and the parts nest again. Neither spends credits.
Download an SVG per sheet and send it to your laser cutter.
More to make
LaserForklaser cut lamp
Laser cut lamp
Laser cut lamp as a parametric cut file. Set the stock and size, then download the SVG or DXF.
CNCForkcnc box
CNC box with lid
CNC box with lid as a parametric cut file. Set the stock and size, then download the SVG or DXF.
ModelForkCommunity
Spice drawer insert
Two separate 200x50 mm wedge-shaped spice rack rows, each with four 45 mm jar pockets 12 mm deep, tilted 15 degrees back so labels face up and out.
LaserForkLaser cut
Round lantern
A two-storey round lantern with a double candle door (two leaves, each hinged on top and bottom pins at its outer side), a diamond cross-hatch lattice with s…
CNCForkCNC cut
Chair - Pointy
Flat-pack side chair with two angular side frames (forward-splayed tapered front legs, a gabled apron and a single raked back post), a seat panel and two che…
ModelForkCommunity
Toothbrush holder
Hollow toothbrush cup with an 8 mm floor drain and a separate drop-in insert with four 12 mm brush holes.