CNC cut
Drawer cabinet
By Byteworks
Finger-jointed carcass with a back and two tabbed shelves, holding three sliding finger-jointed drawers with hand slots.
Prompt that made this
Cabinet with drawers
Made in Voloom from the prompt under the model. Download the cut sheets as they are, or fork a copy to change the material thickness and every size on the right — the joints re-cut to fit, without spending credits.
Make it fit your stock
Measure your sheet first. In the editor, set the thickness to match and every slot and tab re-cuts to fit. Change the sheet size and the parts nest again. Neither spends credits.
Download an SVG per sheet and send it to your CNC router.
More to make
ModelForkCommunity
Box with a hinged lift lid
Five parts: a bin, a hinged lid that follows its curved front, and a foot pedal that lifts the lid through a link bar and push rod.
LaserForkLaser cut
Pitched roof birdhouse
Finger-jointed birdhouse with a front-overhanging pitched roof, a 32 mm entrance hole, a flat perch with a rounded end, and a tall back plate with a hanging…
ModelForkCommunity
Toothbrush holder
Hollow toothbrush cup with an 8 mm floor drain and a separate drop-in insert with four 12 mm brush holes.
LaserForktea light holder
Laser cut tea light holder
Laser cut tea light holder as a parametric cut file. Set the stock and size, then download the SVG or DXF.
CNCForkCNC cut
Workstation desk
A wide flat-pack desk on two tapered, splayed inverted-U leg frames with the desk top resting between them, an upper bracket pressed against the underside of…
