3D print
Prompt that made this
Wall-mounted toilet paper holder. A 90 × 60 mm wall plate, 6 mm thick, with two 4 mm countersunk screw holes. An open arm 150 mm long and 25 mm in diameter comes out of one side so a roll slides on from the free end, with a 10 mm raised lip at the tip to keep the roll on.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Hold a toilet paper roll on a bathroom wall
The plate is screwed to the wall. The arm cantilevers out from the plate and the roll slides on from the free end. The lip at the tip keeps the roll from sliding off.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
ModelForkCommunity
Coffee pod holder
Rectangular coffee-pod tray with a 4 x 3 grid of round 38 mm pockets, 16 mm deep, separated by 1.6 mm walls, on a 1.6 mm floor.
LaserForkLaser cut
Round lantern
A two-storey round lantern with a double candle door (two leaves, each hinged on top and bottom pins at its outer side), a diamond cross-hatch lattice with s…
CNCForkCNC cut
Slot together side table
A 400 × 400 mm side table, 450 mm tall, cut from 18 mm ply: two splayed A-frame end panels with arched feet, tabbed into the top, and a lower shelf that lock…
ModelForkCommunity
Laptop stand
Two sloped 12 degree risers with front lips and a separate 220 mm spreader that slots into 4 mm mortises; three printed parts.
LaserForkhouse number sign
House number sign
House number sign as a parametric cut file. Set the stock and size, then download the SVG or DXF.
CNCForkCNC cut
Drawer cabinet
Finger-jointed carcass with a back and two tabbed shelves, holding three sliding finger-jointed drawers with hand slots.