3D print
Prompt that made this
Laptop stand. Two 180 × 20 × 70 mm triangular risers at 12°, and a separate 220 mm spreader that slots into 4 mm mortises. Front lip 6 mm. Prints as three parts.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Raised, angled desk stand for a laptop
The risers carry the laptop on a 12 degree slope and the front lips stop it sliding off. The spreader tenons into mortises on the inner faces of both risers and holds them at a fixed spacing.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
LaserForkLaser cut
Glueless desk organizer
Open-top desk tray with finger-jointed walls and two crossing dividers; every joint is a mechanical finger, tab or cross-slot, so it assembles without glue.
CNCForkCNC cut
Workstation desk
A wide flat-pack desk on two tapered, splayed inverted-U leg frames with the desk top resting between them, an upper bracket pressed against the underside of…
ModelForkCommunity
Broom mop holder
Wall-mounted broom and mop holder: a 70x50x6 back plate with two 4 mm screw holes and a 30 mm tall C-clip with a front opening and flexible arms that grips h…
LaserForklaser cut lamp
Laser cut lamp
Laser cut lamp as a parametric cut file. Set the stock and size, then download the SVG or DXF.
CNCForkCNC cut
Chair - Rounded
A taller, sleeker flat-pack chair with tapered side frames and a backrest reclined at an angle: the front legs splay forward and narrow toward the foot, and…
ModelForkCommunity
Shower razor holder
Wall-mounted shower razor holder with a screw-mounted back plate, a front-slotted drainage shelf and a front lip.