3D print
Prompt that made this
Wall-mounted broom and mop holder. A 70 × 50 mm back plate, 6 mm thick, with two 4 mm screw holes. A C-shaped clip that grips a handle 22 to 28 mm in diameter, opening at the front with flexible arms, 30 mm tall.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Hanging a broom or mop handle (22 to 28 mm diameter) on a wall
The plate is screwed to the wall. The C-clip ring holds the handle. The front opening is narrower than the handle, so the thin arms flex apart to let it snap in and grip it.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
CNCForkCNC cut
Chair - Pointy
Flat-pack side chair with two angular side frames (forward-splayed tapered front legs, a gabled apron and a single raked back post), a seat panel and two che…
ModelForkCommunity
Shot glass
Tapered shot glass with a thick solid base, a chamfered underside edge, a shallow recess under the base for a flat standing ring, thin walls and an open rim…
LaserForkLaser cut
Two drawer cabinet
Small carcass with a middle shelf and two finger-jointed open-top box drawers stacked in two bays.
CNCForkCNC cut
Drawer cabinet
Finger-jointed carcass with a back and two tabbed shelves, holding three sliding finger-jointed drawers with hand slots.
ModelForkCommunity
Door stop wedge
A 130 x 45 mm door stop wedge rising from 3 mm to 28 mm, with triangular grip ridges on the slope, a lanyard hole near the tall end and a slightly dished und…
LaserForkLaser cut
Round lantern
A two-storey round lantern with a double candle door (two leaves, each hinged on top and bottom pins at its outer side), a diamond cross-hatch lattice with s…