3D print
Prompt that made this
Door stop wedge. 130 mm long, 45 mm wide, rising from 3 mm at the tip to 28 mm at the back. Grip ridges across the top, a finger hole near the tall end for a lanyard, and a slightly concave underside so it does not rock.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Holding a door open on a floor.
The thin tip slides under the door and the slope wedges it tight. The ridges add grip, the dish keeps the bottom from rocking, and the cross hole takes a lanyard.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
ModelForkCommunity
Self draining soap dish
A 120x80x18 mm soap dish with a 4° floor sloping to an open front, six ribs, 3 mm side and back walls, four 3 mm feet at the corners, and a separate drip tra…
LaserForkLaser cut
Glueless desk organizer
Open-top desk tray with finger-jointed walls and two crossing dividers; every joint is a mechanical finger, tab or cross-slot, so it assembles without glue.
CNCForkCNC cut
Slot together side table
A 400 × 400 mm side table, 450 mm tall, cut from 18 mm ply: two splayed A-frame end panels with arched feet, tabbed into the top, and a lower shelf that lock…
ModelForkCommunity
Toilet paper holder
Wall-mounted toilet paper holder: 90x60x6 plate with two countersunk screw holes, a 150 mm long 25 mm diameter arm, and a raised lip at the free tip.
LaserForkLaser cut
Round lantern
A two-storey round lantern with a double candle door (two leaves, each hinged on top and bottom pins at its outer side), a diamond cross-hatch lattice with s…
CNCForkCNC cut
Drawer cabinet
Finger-jointed carcass with a back and two tabbed shelves, holding three sliding finger-jointed drawers with hand slots.