3D print
Prompt that made this
Handheld-console stand sized for a Steam Deck. 110 × 80 mm base, 18 mm yoke slot 128 mm wide, 65° lean, 12 mm USB-C cable slot. Separate yoke that dovetails into the base. No logos.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Desk stand that props a Steam Deck at a 65 degree lean while it charges or plays.
The yoke tenon slides into the base dovetail from the front and is held vertically and laterally by the dovetail. The deck's lower edge sits in the 18 mm slot, rests against the leaned back wall, and is retained by the front lip. The cable notch lets the USB-C cable leave the slot.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
CNCForkCNC cut
Chair - Pointy
Flat-pack side chair with two angular side frames (forward-splayed tapered front legs, a gabled apron and a single raked back post), a seat panel and two che…
ModelForkCommunity
Switch stand
Low desk kickstand block with a 12 mm slot leaning the console at 70 degrees and a cable notch out the back.
LaserForklaser cut organizer
Laser cut desk organizer
Laser cut desk organizer as a parametric cut file. Set the stock and size, then download the SVG or DXF.
CNCForkCNC cut
Chair - Rounded
A taller, sleeker flat-pack chair with tapered side frames and a backrest reclined at an angle: the front legs splay forward and narrow toward the foot, and…
ModelForkCommunity
Mouse bungee
Weighted disc base with a coin pocket underneath, a vertical arm and a C-clip on top that snaps a mouse cable in.
LaserForkLaser cut
Cross leg stool
Round stool with two cross-slotted X legs, a ring at the feet tying them together, and a round seat tabbed into the leg tops.