3D print
Prompt that made this
Handheld-console kickstand, 130 × 20 × 70 mm, 12 mm slot, 70° lean, cable notch. No logos.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Propping a handheld game console upright on a desk while it charges or is played
The console's bottom edge sits in a 12 mm slot tilted 20 degrees from vertical, so the console leans back at 70 degrees. The wide, deep base keeps it from tipping, and the cable notch lets the charging cable leave the slot at the back.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
LaserForkLaser cut
Two drawer cabinet
Small carcass with a middle shelf and two finger-jointed open-top box drawers stacked in two bays.
CNCForkCNC cut
Chair - Rounded
A taller, sleeker flat-pack chair with tapered side frames and a backrest reclined at an angle: the front legs splay forward and narrow toward the foot, and…
ModelForkCommunity
Box with a hinged lift lid
Five parts: a bin, a hinged lid that follows its curved front, and a foot pedal that lifts the lid through a link bar and push rod.
LaserForkLaser cut
Pitched roof birdhouse
Finger-jointed birdhouse with a front-overhanging pitched roof, a 32 mm entrance hole, a flat perch with a rounded end, and a tall back plate with a hanging…
CNCForkCNC cut
Drawer cabinet
Finger-jointed carcass with a back and two tabbed shelves, holding three sliding finger-jointed drawers with hand slots.
