3D print
Prompt that made this
Wall coat hook rail. A 300 × 40 × 10 mm board with three evenly spaced hooks, each hook rising 35 mm, 50 mm out from the board, with a ball end so coats do not slip off. Three countersunk screw holes along the rail for 4 mm screws. Rounded corners.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Wall-mounted coat hook rail
The rail is screwed to the wall through three countersunk holes. Each hook arm projects 50 mm from the board and turns up into a ball-ended post that stops coats from slipping off.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
CNCForkCNC cut
Drawer cabinet
Finger-jointed carcass with a back and two tabbed shelves, holding three sliding finger-jointed drawers with hand slots.
LaserForkhouse number sign
House number sign
House number sign as a parametric cut file. Set the stock and size, then download the SVG or DXF.
ModelForkCommunity
Toothbrush holder
Hollow toothbrush cup with an 8 mm floor drain and a separate drop-in insert with four 12 mm brush holes.
LaserForktea light holder
Laser cut tea light holder
Laser cut tea light holder as a parametric cut file. Set the stock and size, then download the SVG or DXF.
ModelForkCommunity
Coffee pod holder
Rectangular coffee-pod tray with a 4 x 3 grid of round 38 mm pockets, 16 mm deep, separated by 1.6 mm walls, on a 1.6 mm floor.
