3D print
Prompt that made this
Under-desk cable tray. A 220 × 70 × 45 mm U-channel, 2 mm walls, open ends. Two separate L-brackets that screw to the desk underside with 5 mm slots and clip onto the tray lips. Optional end caps that friction-fit the channel.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Hanging a cable tray under a desk to carry power strips and loose cables.
Two L-brackets screw to the desk underside through 5 mm slots. Each bracket leg hangs outside a tray lip, a ledge carries the lip from below, and a nub above the lip stops it lifting off. The tray slides in from the end. Optional plug caps press into the channel ends.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
ModelForkCommunity
Steam Deck stand
Steam Deck stand: 110x80 base with a dovetail groove and a separate 128 mm wide yoke with an 18 mm slot leaning at 65 degrees and a 12 mm cable notch.
CNCForkCNC cut
Slot together side table
A 400 × 400 mm side table, 450 mm tall, cut from 18 mm ply: two splayed A-frame end panels with arched feet, tabbed into the top, and a lower shelf that lock…
LaserForkLaser cut
Pitched roof birdhouse
Finger-jointed birdhouse with a front-overhanging pitched roof, a 32 mm entrance hole, a flat perch with a rounded end, and a tall back plate with a hanging…
CNCForkCNC cut
Workstation desk
A wide flat-pack desk on two tapered, splayed inverted-U leg frames with the desk top resting between them, an upper bracket pressed against the underside of…
LaserForkLaser cut
Two drawer cabinet
Small carcass with a middle shelf and two finger-jointed open-top box drawers stacked in two bays.
ModelForkCommunity
Laptop stand
Two sloped 12 degree risers with front lips and a separate 220 mm spreader that slots into 4 mm mortises; three printed parts.