3D print
Prompt that made this
Locking cable clip for four cables. A 70 × 22 × 14 mm base with four 7.5 mm channels and a separate lid that snaps with a 1.2 mm latch. Optional 4 mm screw holes on the ends.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Holding and organizing four parallel cables of about 7.5 mm diameter on a surface.
Cables lie in four channels in the base. The lid presses down onto the cables, and its two skirts flex outward until the barbs drop into the grooves on the base faces, locking it. Optional end screws fix the clip down.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
LaserForkLaser cut
Two drawer cabinet
Small carcass with a middle shelf and two finger-jointed open-top box drawers stacked in two bays.
ModelForkCommunity
Steam Deck stand
Steam Deck stand: 110x80 base with a dovetail groove and a separate 128 mm wide yoke with an 18 mm slot leaning at 65 degrees and a 12 mm cable notch.
CNCForkCNC cut
Drawer cabinet
Finger-jointed carcass with a back and two tabbed shelves, holding three sliding finger-jointed drawers with hand slots.
LaserForkLaser cut
Cross leg stool
Round stool with two cross-slotted X legs, a ring at the feet tying them together, and a round seat tabbed into the leg tops.
ModelForkCommunity
Mouse bungee
Weighted disc base with a coin pocket underneath, a vertical arm and a C-clip on top that snaps a mouse cable in.
