3D print
Prompt that made this
Furniture leg riser that lifts a bed or sofa leg by 50 mm. A square tapered block, 90 × 90 mm at the base and 75 × 75 mm at the top, with a 55 × 55 mm pocket 15 mm deep in the top for the leg, ribs inside the hollow body, and a 4 mm chamfer round the bottom edge.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Raising a bed or sofa leg by 50 mm
The leg sits in the top pocket. Load passes through the ceiling and ribs into the walls and down to the floor. The wide tapered base spreads the load.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
CNCForkCNC cut
Workstation desk
A wide flat-pack desk on two tapered, splayed inverted-U leg frames with the desk top resting between them, an upper bracket pressed against the underside of…
LaserForkLaser cut
Finger jointed desktop organizer
Finger-jointed desktop organizer with a front-open carcass, two tabbed shelves and three open-top drawers, each with a finger-pull slot.
ModelForkCommunity
Bike wall hook
Wall-mounted bike hook: a vertical 40x90x8 back plate with two countersunk 5 mm screw holes 60 mm apart, a rounded J-shaped arm 30 wide that projects 110 mm…
CNCForkCNC cut
Slot together side table
A 400 × 400 mm side table, 450 mm tall, cut from 18 mm ply: two splayed A-frame end panels with arched feet, tabbed into the top, and a lower shelf that lock…
LaserForkhouse number sign
House number sign
House number sign as a parametric cut file. Set the stock and size, then download the SVG or DXF.
