3D print
Prompt that made this
Floating shelf bracket. An L bracket with a 120 mm vertical wall leg and a 150 mm horizontal arm, both 25 mm wide and 6 mm thick, with a triangular gusset between them. Two countersunk 5 mm screw holes in the wall leg, two 4 mm holes in the arm for screwing up into the shelf.
Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.
Why this one
Supporting a shelf board from a wall without visible fixings on top
The wall leg is screwed to the wall through two countersunk holes. The shelf sits on the arm and is screwed up into its underside through two arm holes. The gusset carries the bending load from the arm into the wall leg.
How to print
Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.
More to make
LaserForkLaser cut
Cross leg stool
Round stool with two cross-slotted X legs, a ring at the feet tying them together, and a round seat tabbed into the leg tops.
ModelForkCommunity
Coffee pod holder
Rectangular coffee-pod tray with a 4 x 3 grid of round 38 mm pockets, 16 mm deep, separated by 1.6 mm walls, on a 1.6 mm floor.
CNCForkCNC cut
Workstation desk
A wide flat-pack desk on two tapered, splayed inverted-U leg frames with the desk top resting between them, an upper bracket pressed against the underside of…
LaserForkLaser cut
Round lantern
A two-storey round lantern with a double candle door (two leaves, each hinged on top and bottom pins at its outer side), a diamond cross-hatch lattice with s…
ModelForkCommunity
Plastic wine glass
Clear stemmed wine goblet: a solid of revolution with a thin flat foot, slender stem with a small bead, a softly filleted stem-to-bowl junction, and an open…
