Multiboard spray can holder

By Byteworks

Multiboard spray can holder: 3x2 cell back with Multiconnect keyhole slots, a collared 68 mm hole at the bottom edge, and a drop arm carrying a closed base with a locating ring. The shelf and base have rounded front ends that follow the can circle instead of square corners.

Model
stl3mfstepobjglbbrep
Customize for free
Multiboard spray can holder, 3D printable model

Prompt that made this

Multiboard spray can holder: a 3 × 2 cell back with Multiconnect slots and a 4 mm shelf at its bottom edge with a 68 mm round hole, ringed by a 20 mm tall, 2.4 mm collar, for a standard 65 mm spray can.

Open the model

Made in Voloom from the prompt under the model. Sign in to download the STL, or fork it so every size on the right becomes editable — without spending credits.

Why this one

Hanging a standard 65 mm spray can on a Multiboard wall

The back plate hooks onto the board with Multiconnect slots. The can slides through the collared shelf hole, its butt stops against the closed base carried by the drop arm, and the lower ring locates the can foot while the upper collar keeps it upright.

How to print

Download the STL, 3MF, or STEP and slice it. Fork the design to change a size before you print.

More to make

  • Opengrid pliers holder, 3D printable modelModelFork

    opengrid pliers holder

    openGrid pliers holder

    openGrid pliers holder as a parametric solid. Change a size, then download the STL.

  • Plate cam and follower, 3D printable modelModelFork

    Community

    Plate cam and follower

    Four separate parts: a base plate, a 50 mm cam disc with one raised lobe, a flat-faced follower on a vertical slide, and the pin the cam turns on.

  • Steam frame controller stand, 3D printable modelModelFork

    steam frame controller stand

    Steam Frame controller stand

    Steam Frame controller stand as a parametric solid. Change a size, then download the STL.

  • 18650 holder 4x, 3D printable modelModelFork

    Community

    18650 holder 4x

    Four-cell 18650 holder with round open-top cradles between two slotted end walls and a bottom mounting tab with a 3 mm hole on each end.

  • Steam frame wall mount, 3D printable modelModelFork

    steam frame wall mount

    Steam Frame wall mount

    Steam Frame wall mount as a parametric solid. Change a size, then download the STL.

  • Raspberry pi 5 case, 3D printable modelModelFork

    Community

    Raspberry pi 5 case

    Two-part Raspberry Pi 5 case sized to the 85x56 mm board: a deep, hollow, rounded-corner base with a 2.5 mm floor, four tubular standoffs, clearly cut port o…